MyDipkit is a do it yourself version of the commercial process known as water transfer imaging. This allows you to process parts on a small scale in your home. The kit contains the printed film, chemicals, and basic supplies needed for processing parts at home. You will need to provide a container for dipping the items in. You will also need to supply warm water, and the item to be decorated. With this kit you will be able to camo dip your own items. Take your time and
do not rush the process!
The procedure
in 6 simple steps:
1 - Clean the part: The part must be free of all dirt, oils, wax, grease, loose paint or other containments that could affect the finished product.
2 - Prep the part: Scuff and
clean the surface. Mask off areas not to be printed on etc. Primer the part.
3 - Paint the part: Spray the part with the appropriate base coat.
4 - Dip the part: Make sure
the item is dry before
dipping! Item is submerged into dipping container with the film floating on top of the water.
5 - Rinse the part: Rinse the part
(directly after dipping) to remove any residue from the dipping procedure.
6 - Finish coat: Finish the item with the spray clear coat. (Not shown in the video below..)
